3
Select a RADIUS server and check the Remove checkbox.
4
Click Apply Changes.
The RADIUS server is removed from the RADIUS Servers list.
Defining RADIUS Servers Using CLI Commands
The following table summarizes the CLI commands for working with fields in the OOB RADIUS
Settings page.
Table 6-13. Out-of-Band RADIUS Settings CLI Commands
CLI Command
radius-server host ip-
address [auth-port auth-
port-number ] [timeout
timeout ] [retransmit
retries] [deadtime
deadtime ] [key key-
string ] [source source ]
[priority priority ]
no radius-server host ip-
address
radius-server source-ip
source
no radius-server-ip
radius-server timeout
timeout
no radius-server deadtime Sets the dead time to 0.
The following is an example of the CLI commands:
console(config)#interface out-of-band eth 1
console radius-server host oob/10.2.2.2 key 123
134
Configuring System Information
Description
Specifies a RADIUS server host.
Deletes a specified RADIUS server host.
Specifies the source IP address that is used
for communication with RADIUS servers.
Returns to default.
Sets the interval for which a router waits for
a server host to reply.