Dell PowerConnect 6024 User Manual page 236

Figure 7-8. Add ACE to IP Based ACL
The Add ACE to IP Based ACL page contains the following fields:
ACL Name — User-defined ACLs.
New ACE Priority — ACE priority that determines which ACE is matched to a packet based on a
first-match basis.
Protocol — Enables creating an ACE based on a specific protocol.
Select from List — Click to select from a protocols list on which ACE can be based.
Protocol ID To Match— Click to add a user-defined protocol by which packets are matched
to the ACE.
NOTE:
Source Port— The TCP/UDP source port. This field is active only if 800/6-TCP or 800/17-UDP are
selected in the Select from List drop-down menu.
Destination Port— The TCP/UDP destination port. This field is active only if 800/6-TCP or
800/17-UDP are selected in the Select from List drop-down menu.
Source IP Address—Matches the source port IP address to which packets are addressed to the
ACE.
Wild Card Mask — Source IP address wildcard mask.Wild card masks specify which bits are used
and which bits are ignored. A wild card mask of 255.255.255.255 indicates that no bit is important.
A wildcard of 0.0.0.0 indicates that all the bits are important.
Dest. IP Address — Matches the destination port IP address to which packets are addressed to the
ACE.
246
Configuring Switch Information
Using "any" specifies that all IP protocols are selected.