Dvmrp Neighbor Table - Dell PowerConnect 6024 User Manual

DVMRP Neighbor Table

The DVMRP Neighbor Table page contains information about neighboring port interfaces.
DVMRP neighbors are discovered through DVMRP messages. To open the DVMRP Neighbor
Table page, click Router→ IP Multicast→ DVMRP Neighbor Table in the tree view.
Figure 8-27. DVMRP Neighbor Table
Interface — Interface number on which DVMRP is enabled.
Neighbor — IP address of the neighboring interface.
Up Time — Amount of time since the neighboring interface became a neighbor.
Expiry Time — Indicates the minimum amount of time before the interface is timed out.
Major Version — The neighboring router's major version number.
Minor Version — The neighboring router's minor version number.
State — The neighboring device state.
Viewing the DVMRP Neighbor Table Using CLI Commands
The following table contains the CLI command for viewing the DVMRP Neighbor Table.
Table 8-23. DVMRP Neighbor Table CLI Commands
CLI Command
show ip dvmrp neighbor
[ethernet interface-number |
vlan vlan-id | port-channel
number ]
The following is an example of the CLI command:
384
Configuring Routing
Description
Shows the DVMRP Neighbor table.