Static Multicast Routing Commands; Ip Igmp Snooping Vlan Mrouter; Table 37-4 Static Multicast Routing Commands - SMC Networks TigerStack II SMC8926EM Management Manual

Static Multicast Routing Commands

This section describes commands used to configure static multicast interfaces on
the switch.
Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter

ip igmp snooping vlan mrouter

This command statically configures a multicast router port on the specified VLAN.
Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4093)
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
• port-channel channel-id (Range: 1-32)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not always be
able to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on your router, you can manually configure that interface to join all the
current multicast groups.
Example
The following shows how to configure port 11 as a multicast router port within VLAN 1:
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#

Table 37-4 Static Multicast Routing Commands

Function
Adds a multicast router port
Shows multicast router ports
Static Multicast Routing Commands
37
Mode Page
GC 37-9
PE 37-10
37-9