Lacp Agg Partner Admin System Id - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Link Aggregation Commands

lacp agg partner admin system id

Configures the partner administrative system ID for a dynamic aggregate group port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin system id
partner_admin_system_id
lacp agg [ethernet | fastethernet | gigaethernet] slot/port no partner admin system id
Syntax Definitions
ethernet
fastethernet
gigaethernet
slot
port
partner_admin_system_id
Defaults
parameter
partner_admin_system_id
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a partner administrative system ID from a slot and port
associated with a dynamic aggregate group.
•
The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
Chapter 1, "Ethernet Port Commands,"
Examples
-> lacp agg 3/1 partner admin system id 00:20:da:05:f6:23
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Documents that the port is 10 Mbps Ethernet.
Documents that the port is 100 Mbps Fast Ethernet.
Documents that the port is Gigabit Ethernet.
The slot number for this aggregate.
The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
The MAC address of the remote dynamic aggregate group in the hexa-
decimal format xx:xx:xx:xx:xx:xx.
default
0
for information on CLI commands to configure Ethernet ports.
June 2012 page 8-33