Show Mac-Address-Table All Count - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Source Learning Commands

show mac-address-table all count

Displays Source Learning MAC Address Table statistics for both VLAN and VPLS MAC addresses.
show mac-address-table all count
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
This command displays dynamically learned and permanent MAC address for both VLANs and VPLS
services. For more information on VPLS, see the "VPLS Commands" chapter in this guide.
•
Use the show mac-address-table count command to display statistics for VLAN MAC addresses
only.
Examples
-> show mac-address-table all count
Mac Address Table Count:
Permanent Address Count
DeleteOnReset Address Count
DeleteOnTimeout Address Count
Dynamic Learned Address Count
Static Multicast Address Count
Permanent VPLS Address Count
Dynamic Learned VPLS Address Count = 21038,
Total MAC Address In Use
output definitions
Permanent Address Count
DeleteOnReset Address Count The number of static MAC addresses configured on the switch with a
DeleteOnTimeout Address
Count
Dynamic Learned Address
Count
OmniSwitch CLI Reference Guide
= 0,
= 0,
= 0,
= 5,
= 0,
= 1,
= 21044
The number of static MAC addresses configured on the switch with a
permanent management status (MAC address is never aged out).
reset management status (MAC address is deleted on the next switch
reboot).
The number of static MAC addresses configured on the switch with a
timeout management status (MAC address ages out according to the
MAC address table aging timer value).
The number of MAC addresses learned by the switch. These are MAC
addresses that are not statically configured addresses.
June 2012 page 4-33