Bridge 1X1 Connection - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Distributed Spanning Tree Commands

bridge 1x1 connection

Configures the connection type for a port or an aggregate of ports for a 1x1 mode VLAN instance.
bridge 1x1 vid {slot/port | logical_port} connection {noptp | ptp | autoptp | edgeport}
Syntax Definitions
vid
slot/port
logical_port
noptp
ptp
autoptp
edgeport
Defaults
By default, the link connection type is set to auto point-to-point.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command is an explicit Spanning Tree command that only applies to the specified VLAN instance
regardless of which operating mode (flat or 1x1) is active on the switch.
•
If the switch is running in the flat mode when this command is used, the specified connection type for
the port is not active for the specified VLAN instance until the operating mode for the switch is
changed to the 1x1 mode.
•
Note that when a configuration snapshot is taken of the switch, all Spanning Tree commands are saved
in their explicit format.
•
A port is considered connected to a point-to-point LAN segment if the port belongs to a link aggregate
of ports or if autonegotiation determines the port should run in full duplex mode or if full duplex mode
was administratively set. Otherwise, the port is considered connected to a no point-to-point LAN
segment.
•
Rapid transition of a designated port to forwarding can only occur if the port connection type is defined
as a point-to-point or an edge port. Rapid transition of an alternate port role to a root port role is not
affected by the port connection type definition.
OmniSwitch CLI Reference Guide
An existing VLAN ID number (1–4094).
Enter the slot number for the module and the physical port number on
that module (for example, 3/1 specifies port 1 on slot 3).
Link aggregate ID number (0–31).
Defines port connection type as no point-to-point link.
Defines port connection type as point-to-point link.
Specifies that switch software automatically defines connection type as
point-to-point or no point-to-point and whether or not the port is an
edge port.
This parameter is currently not supported. Use the
edge or bridge 1x1 auto-edge
June 2012
bridge 1x1 admin-
command to configure edge port status.
page 7-97