interfaces autoneg
Enables or disables auto negotiation on a single port, a range of ports, or an entire Network Interface (NI).
interfaces {slot | slot/port[-port2]} autoneg {enable | disable | on | off}
Syntax Definitions
slot
slot/port[-port2]
enable
disable
on
off
Defaults
parameter
enable | disable | on | off enable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
If auto negotiation is disabled, auto MDIX, auto speed, and auto duplex are not accepted. See the
interfaces crossover
•
Copper Gigabit ports do not support disabling of auto negotiation.
•
Enter a slot number to configure auto-negotiation for all interfaces on a specific slot.
•
Enter a slot and port number or a range of port numbers to configure auto-negotiation for a specific
interface or range of interfaces.
Examples
-> interfaces 3 autoneg disable
-> interfaces 3/1 autoneg disable
-> interfaces 3/1-4 autoneg disable
Release History
Release 6.1; command was introduced.
page 1-10
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Enables auto negotiation.
Disables auto negotiation.
Same as enable.
Same as disable.
default
command on
page 1-12
for more information.
Ethernet Port Commands
OmniSwitch CLI Reference Guide
June 2012