Erp-Ring Protected-Vlan - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

erp-ring protected-vlan

Configures a VLAN as a protected VLAN for an ERP ring. The ring ports associated with the specified
ring ID are tagged with the protected VLAN ID.
erp-ring ring_id protected-vlan vlan_id1[-vlan_id2] [vlan_id1[-vlan_id2]]
no erp-ring ring_id protected-vlan [vlan_id1[-vlan_id2]]
Syntax Definitions
ring_id
vlan_id1[-vlan_id2]
Defaults
NA
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove a protected VLAN from the ERP ring configuration.
•
The ERP ring ID number specified must already exist in the switch configuration, unless the VLAN ID
specified belongs to a VLAN Stacking SVLAN.
•
The VLAN ID specified must already exist in the switch configuration.
•
Specify only static VLAN IDs; dynamic VLANs are not configurable as protected VLANs.
•
A protected VLAN can belong to only one ERP ring at a time.
•
The specified protected VLAN ID must not participate in a Spanning Tree instance that is associated
with non-ERP VLANs. This may require changing the Spanning Tree configuration for the VLAN ID
prior to using this command.
•
A SVLAN with two ERP VPA type NNI ports will be automatically configured as an ERP protected
VLAN on a ring if the two NNI ports constitute its ring ports.
•
Deletion of SVLAN-NNI binding results in removal of the SVLAN from the corresponding ERP
protected VLAN database.
Examples
-> erp-ring 1 protected-vlan 11
-> erp-ring 1 protected-vlan 12-20 25-40 100
-> erp-ring 2 protected-vlan 30-50
-> no erp-ring 1 protected-vlan
-> no erp-ring 1 protected-vlan 25-40
page 9-6
The ERP ring ID number. The valid range is 1- 2147483647.
The VLAN ID number. To specify multiple VLAN IDs in a single
command, use a hyphen to indicate a contiguous range of VLAN IDs
and a space to separate multiple VLAN ID entries (e.g., 10-20 30 100).
Ethernet Ring Protection Commands
OmniSwitch CLI Reference Guide June 2012