Modifying The Partner Port Administrative Key; Modifying The Partner Port System Id - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

Configuring Dynamic Link Aggregation
Note. Since individual bits with the LACPDU frame are set with the linkagg lacp port partner admin
state command you can set some bits on and restore other bits to default values within the same
command. For example, if you wanted to restore bit 2 (aggregate) to its default settings and set bit 0
(active) on dynamic aggregate partner port 1 in slot 7, enter:
-> no linkagg lacp port 7/1 partner admin-state active aggregate

Modifying the Partner Port Administrative Key

By default, the "administrative key" of the dynamic aggregate partner port is 0. The following subsections
describe how to configure a user-specified value and how to restore the value to its default value with the
linkagg lacp agg partner admin-key
Configuring the Partner Port Administrative Key
You can configure the administrative key for the dynamic aggregate partner port to a value ranging from 0
to 65535 enter linkagg lacp port, the slot number, a slash (/), the port number, partner admin-key, and
the user-specified partner port administrative key.
For example, to modify the administrative key of a dynamic aggregate group partner port 1 in slot 6 to
1000 enter:
-> linkagg lacp port 6/1 partner admin-key 1000
For example, to modify the administrative key of a dynamic aggregate group partner port 1 in slot 6, enter:
-> linkagg lacp port 6/1 partner admin-key 1000
Restoring the Partner Port Administrative Key
To remove a user-configured administrative key from the configuration set on a dynamic aggregate group
partner port, use the no form of the
linkagg lacp agg, the slot number, a slash (/), the port number, and partner admin-key keyword.
For example, to remove the user-configured administrative key from dynamic aggregate partner port 1 in
slot 6, enter:
-> no linkagg lacp port 6/1 partner admin-key

Modifying the Partner Port System ID

By default, the partner port system ID ( the MAC address used as the system ID on dynamic
aggregate partner ports) is 00:00:00:00:00:00. The following subsections describe how to configure a
user-specified value and how to restore the value to its default value with the
admin system-id command.
OmniSwitch AOS Release 7 Network Configuration Guide
Modifying Dynamic Link Aggregate Group Parameters
command.
linkagg lacp agg partner admin-key
March 2011
command by entering no
linkagg lacp port partner
page 7-23