Ethernet Port Commands
show interfaces collisions
Displays interface collision information (for example, number of collisions and number of retries).
show interfaces [slot | slot/port[-port2]] collisions
Syntax Definitions
slot
slot/port[-port2]
Defaults
By default, information is displayed for all ports on all modules.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Enter a slot number to display information for all interfaces on that slot.
•
Enter a slot and port number or a range of port numbers to display information for a specific interface
or a range of interfaces.
•
These counters do not apply to Gigabit Ethernet traffic.
Examples
-> show interfaces 2/1 collisions
02/01,
Rx Collisions = 6.56E18,
Rx Multiple Collisions = 6325235326,
output definitions
Slot/Port
Tx Collisions
Tx Single Collision
Tx Multiple Collisions
Tx Excessive Retries
Rx Collisions
Rx Single Collision
OmniSwitch CLI Reference Guide
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Rx Single Collision = 345464364,
Rx Excessive Collisions = 5.65E19
Interface slot and port number.
Number of transmit collisions.
Number of successfully transmitted frames for which transmission was
inhibited by one collision.
Number of successfully transmitted frames for which transmission was
inhibited by multiple collisions.
Number of frames for which transmission fails due to excessive colli-
sions.
Number of receive collisions.
Number of successfully received frames for which reception was
inhibited by one collision.
June 2012
page 1-85