Show Interfaces Capability - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show interfaces capability

Displays default auto negotiation, speed, duplex, flow, and cross-over settings for a single port, a range of
ports, or all ports on a Network Interface (NI) module.
show interfaces [slot | slot/port[-port2]] capability
Syntax Definitions
slot
slot/port[-port2]
Defaults
By default, information is displayed for all ports on all modules.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Enter a slot number to display information for all interfaces on that slot.
•
Enter a slot and port number or a range of port numbers to display information for a specific interface
or a range of interfaces.
•
The show interfaces capability command displays defaults settings in two rows of data for each port.
The first row of data, identified by the label CAP, displays the valid user-defined configuration settings
available for the port. The second row, identified by the label DEF, displays the default settings for the
port.
Examples
-> show interfaces 5/1 capability
Slot/Port AutoNeg
-----------+---------+--------+-----------+----------+----------
5/1 CAP EN/DIS
5/1 DEF
output definitions
Slot
Port
AutoNeg
page 1-72
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Flow Crossover
EN/DIS MDI/X/Auto
EN EN Auto
The slot number.
The port number
In the row labeled CAP, the field displays the valid auto negotiation
configurations for the port. In the row label DEF, the field displays the
default auto negotiation settings for the port. The possible values are
EN (enabled) or DIS (disabled).
Speed Duplex
10/100/1G Full/Half
Auto Auto
OmniSwitch CLI Reference Guide
Ethernet Port Commands
June 2012