Ethernet Port Commands
link-fault-propagation group source
Configures the source port assignments for a Link Fault Propagation (LFP) group.
link-fault-propagation group group_id source {port slot/port[-port2] | linkagg agg_id[-agg_id2]}
no link-fault-propagation group group_id source {port slot/port[-port2] | linkagg agg_id[-agg_id2]}
Syntax Definitions
group_id
slot/port[-port2]
agg_id[-agg_id2]
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a source port association with the specified LFP group.
•
Make sure the LFP group specified with this command already exists in the switch configuration.
•
Configuring the source ports and destinations ports for the specified LFP group is allowed within the
same command (see the examples on this command page).
•
A group can have a maximum of 48 source ports and 48 destination ports.
•
A maximum of 48 link aggregates is supported, regardless of the number of ports in each aggregate in
a group.
•
A port/linkagg added as a source/destination port for a particular group cannot be added as a destina-
tion/source port for this group or for any other group.
•
If a port is recovered due to the Interface Recovery Timer, then the port will revert to the shutdown
state if the error persists.
Example
-> link-fault-propagation group 1 source port 1/2
-> link-fault-propagation group 1 source port 1/2-5 2/3
-> link-fault-propagation group 1 source linkagg 1
-> link-fault-propagation group 1 source linkagg 1-3
-> link-fault-propagation group 1 source port 2/3 destination port 1/6
-> link-fault-propagation group 1 source port 3/1-5 destination linkagg 6
-> no link-fault-propagation group 1 destination port 1/10
OmniSwitch CLI Reference Guide
An existing LFP group ID number. The valid range is 1–8.
The slot and port number (3/1). Use a hyphen to specify a range of ports
and/or a space to specify multiple port entries (3/1-10 4/1 4/5 5/10).
The link aggregate ID number. Use a hyphen to specify a range of IDs
and/or a space to specify multiple ID entries (1-5 10 12).
June 2012
page 1-139