Show Source-Learning - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show source-learning

Displays the source learning status of a port or link aggregate of ports.
show source-learning [port slot/port[-port2] | linkagg linkagg_num]
Syntax Definitions
slot/port1
-port2
linkagg_num
Defaults
By default, the source learning status for all switch ports and link aggregates is displayed.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the port slot/port or linkagg linkagg_num parameters to display the source learning status for a
specific port or link aggregate ID.
•
When the source learning status is configured for a link aggregate ID, it affects all the ports that are
members of the link aggregate. However, source learning status cannot be configured on individual
ports which are members of the link aggregate.
Example
-> show source-learning
port source-learning
-----+-------------
1/1 disabled
1/2 enabled
1/3 disabled
-> show source-learning port 1/2
port source-learning
-----+-------------
1/2 disabled
-> show source-learning linkagg 10
port source-learning
-----+-------------
0/10 disabled
page 4-36
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
Specifies the link aggregate identifier.
Source Learning Commands
OmniSwitch CLI Reference Guide June 2012