Mac-Address-Table Vpls Permanent Sap - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

mac-address-table vpls permanent sap

Configures a static MAC address and associates that address with the specified Service Access Point
(SAP) ID for the specified Virtual Private LAN Service (VPLS).
mac-address-table vpls service-id permanent mac-address sap {sap-id | linkagg sap-id}
no mac-address-table vpls service-id permanent mac-address
no mac-address-table vpls service-id learned [sap sap-id | linkagg sap-id] mac-address
Syntax Definitions
service-id
mac-address
sap-id
learned
Defaults
N/A
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to remove the configured static MAC from the source learning FDB.
•
The specified VPLS ID and SAP ID must already exist in the VPLS configuration for the switch. See
the "VPLS Commands" chapter in this guide for information about how to configure a VPLS and SAP.
•
A SAP ID is comprised of an access (customer-facing) port or link aggregate and an encapsulation
value that is used to identify the type of customer traffic to map to the associated service.
•
Static MACs associated with a SAP are classified as local MACs. A local MAC is used by the associ-
ated VPLS so that MAC addresses are not learned on the edge device.
•
A MAC address can participate in only one static MAC address entry (local or remote) for a specific
VPLS.
•
Static MAC addresses configured on one edge device are not propagated to other edge devices associ-
ated with the same VPLS instance. Each edge device has an independent forwarding database for the
associated VPLS.
Examples
-> mac-address-table vpls 10 permanent 00:00:da:3e:44:01 sap 1/2:100
-> mac-address-table vpls 10 permanent 00:00:da:3e:44:01 sap linkagg 10:100
page 4-4
An existing VPLS ID number.
A 48-bit MAC address (aa:bb:cc:dd:ee:ff). Valid addresses are any non-
broadcast, non-multicast MAC, and non-IEEE reserved addresses.
The access slot and port number or link aggregate ID (0–31) and encap-
sulation value for an existing SAP (e.g., 1/10:0, 1/12:all, 20:150, 10:all).
Specifies that the MAC address is a dynamically learned address. This
option is only available with the no form of this command.
Source Learning Commands
OmniSwitch CLI Reference Guide June 2012