erp-ring guard-timer
Configures the guard timer value for the specified ERP ring node. The guard timer is used to prevent ring
nodes from receiving outdated Ring Automatic Protection Switching (R-APS) messages. During the
amount of time determined by this timer, all received R-APS messages are ignored by the ring protection
control process.
erp-ring ring_id guard-timer guard_timer
no erp-ring ring_id guard-timer
Syntax Definitions
ring_id
guard_timer
Defaults
parameter
guard_timer
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to set the timer back to the default value of 50 centi-secs.
•
The specified ring ID must already exist in the switch configuration.
Examples
-> erp-ring 1 guard-timer 10
-> no erp-ring 1 guard-timer
Release History
Release 6.3.4; command was introduced.
Related Commands
erp-ring
show erp
MIB Objects
alaErpRingId
alaErpRingGuardTimer
page 9-14
An existing ERP ring ID number. The valid range is 1–2147483647.
The guard timer value. The valid range is 1–200 centi-secs.
default
50
Configures an ERP ring.
Displays the ERP ring configuration for the switch.
Ethernet Ring Protection Commands
OmniSwitch CLI Reference Guide
June 2012