Ip Route-Map Match Ipv6 Address - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IP Commands

ip route-map match ipv6 address

Matches the route with the specified IPv6 address or an address defined in the specified IPv6 access list.
ip route-map route-map-name [sequence-number number] match ipv6-address {access-list-name |
ipv6_address/prefixLen [redist-control {all-subnets | no-subnets | aggregate}] [permit | deny]
no ip route-map route-map-name [sequence-number number] match ipv6-address ipv6_address/prefix-
Len [redist-control {all-subnets | no-subnets | aggregate}] [permit | deny]
Syntax Definitions
route-map-name
number
access-list-name
ipv6_address/prefixLen
all-subnets
no-subnets
aggregate
permit
deny
Defaults
parameter
number
permit | deny
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to delete the match ipv6-address redist-control parameter in the
route map.
•
Specify either the name of an existing IPv6 access list or an IPv6 address/prefix length with this
command.
OmniSwitch CLI Reference Guide
The name of the route map (up to 20 characters).
A number that links together the route maps. The range is 1–100.
The name of an IPv4 access list that contains IPv4 addresses to match.
The destination IPv6 address along with the prefix length of the routes
to be redistributed.
Redistributes all the subnet routes that match the network portion of the
IP address as specified by the mask length.
Redistributes only those routes that exactly match the IP address and the
mask length.
Redistributes an aggregate route if there are one or more routes that
match the IPv6 address.
Permits a route based on the IPv6 address or prefix constrained by
redist-control.
Denies a route based on the IPv6 address or prefix constrained by redist-
control.
default
50
permit
June 2012 page 14-39