Chapter 5 Vlan Management Commands - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

VLAN management software handles VLAN configuration and the reporting of VLAN configuration
changes to other switch tasks. A VLAN defines a broadcast domain that contains physical ports and can
span across multiple switches. All switches contain a default VLAN 1. Physical switch ports are initially
assigned to VLAN 1 until they are statically or dynamically assigned to other VLANs.
This chapter includes descriptions of VLAN management commands used to create, modify or remove
VLANs. These commands allow you to enable or disable Spanning Tree Protocol (STP) and Authentica-
tion on a VLAN, add or remove virtual router interfaces, statically assign physical switch ports to a default
VLAN, and display VLAN configuration information.
The VLAN management commands comply with RFC 2674.
MIB information is as follows:
Filename: AlcatelIND1VlanManager.mib
Module: ALCATEL-IND1-VLAN-MGR-MIB
A summary of the available commands is listed here:
vlan
vlan stp
vlan mobile-tag
vlan authentication
vlan source-learning
vlan mtu-ip
vlan port default
show vlan
show vlan port
show vlan router mac status
show vlan gvrp
show vlan ipmvlan
OmniSwitch CLI Reference Guide
5 VLAN Management
June 2012
Commands
page 5-1