Ip Route-Map Set Community - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IP Commands

ip route-map set community

Configures the community name of the route being redistributed into BGP.
ip route-map route-map-name [sequence-number number] set community community-string
no ip route-map route-map-name [sequence-number number] set community community-string
Syntax Definitions
route-map-name
number
community-string
Defaults
parameter
number
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to delete the set community parameter in the route map.
•
All route maps having the same name but different sequence numbers are linked together and
processed in order of increasing sequence number.
•
The route-map-name and sequence-number should exist before you configure this set criteria.
Examples
-> ip route-map 111 sequence-number 50 set community 29
-> no ip route-map 111 sequence-number 50 set community 29
Release History
Release 6.1.3; command was introduced.
Related Commands
ip route-map action
show ip route-map
OmniSwitch CLI Reference Guide
The name of the route map (up to 20 characters).
A number that links together the route maps. The range is 1–100.
Defines a community for an aggregate route. Community names range
from 0 to 70 characters.
default
50
Creates a route map for redistribution and sets the status of the route
map to permit or deny.
Displays the configured IP route maps.
June 2012 page 14-61