Lldp Tlv Med - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

lldp tlv med

Configures whether or not LLDP-MED TLVs are included in transmitted LLDPDUs.
lldp {slot/port | slot | chassis} tlv med {power | capability | network policy} {enable | disable}
Syntax Definitions
slot/port
slot
chassis
power
capability
network policy
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The ports specified with this command must already be configured to transmit LLDPDUs.
•
Using the slot or chassis parameter with this command overrides the existing configuration for any
individual ports on the specified slot number or for all ports on the switch.
•
The lldp tlv med power version of this command applies only to PoE units.
•
Before enabling the Power MED TLV, use the
on all ports in a specific slot.
Examples
-> lldp 4/4 tlv med power enable
-> lldp 4/3 tlv med capability enable
-> lldp 4 tlv med power disable
-> lldp 4 tlv med network-policy enable
-> lldp chassis tlv med network-policy enable
page 12-24
Slot number for the module and physical port number on that module
(for example, 3/1 specifies port 1 on slot 3).
The slot number for a specific module.
All ports on the switch.
Includes the extended POE TLV in transmitted LLDPDUs.
Includes the Capabilities TLV in transmitted LLDPDUs.
Includes the Network Policy TLV in transmitted LLDPDUs.
Enables the transmission of LLDP-MED TLV in LLDPDUs.
Disables the transmission of LLDP-MED TLV in LLDPDUs.
default
disable
lanpower start
802.1AB Commands
command to activate PoE on a port or
OmniSwitch CLI Reference Guide June 2012