Source Learning Commands
show mac-address-table count
Displays Source Learning MAC Address Table statistics for VLAN MAC addresses.
show mac-address-table count [mac_address] [slot slot | slot/port] [linkagg link_agg] [vid | vid1-vid2]
Syntax Definitions
mac_address
slot | slot/port
link_agg
vid
Defaults
By default, the count statistics are displayed for all MAC addresses contained in the MAC address table.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
To display statistics for all ports on one slot, specify only the slot number for the slot parameter value.
•
Note that only one VLAN entry—a single VLAN ID or a range of VLAN IDs— is allowed with this
command. Multiple entries are not accepted.
Examples
-> show mac-address-table count
Mac Address Table count:
Permanent Address Count
DeleteOnReset Address Count
DeleteOnTimeout Address Count
Dynamic Learned Address Count
Static Multicast Address Count
Total MAC Address In Use
-> show mac-address-table count 10-20
Mac Address Table count:
Permanent Address Count
DeleteOnReset Address Count
DeleteOnTimeout Address Count
Dynamic Learned Address Count
Static Multicast Address Count
Total MAC Address In Use
OmniSwitch CLI Reference Guide
A 48-bit MAC address (aa:bb:cc:dd:ee:ff). Valid addresses are any
non-broadcast, non-multicast MAC, and non-IEEE reserved addresses.
Slot number for the module or the slot number and the physical port
number on that module (e.g., 3/1 specifies port 1 on slot 3).
Enter a link aggregate ID number (0–31). See
gation Commands."
VLAN ID number (1–4094).
= 1
= 0
= 0
= 6
= 0,
= 7
= 0
= 0
= 0
= 28
= 0,
= 28
June 2012
Chapter 8, "Link Aggre-
page 4-29