Lacp Agg Partner Admin System Priority - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Link Aggregation Commands

lacp agg partner admin system priority

Configures the partner system priority for a dynamic aggregate group port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin system priority
partner_admin_system_priority
lacp agg [ethernet | fastethernet | gigaethernet] slot/port no partner admin system priority
Syntax Definitions
ethernet
fastethernet
gigaethernet
slot
port
partner_admin_system_priority The priority of the remote switch's dynamic aggregate group to which
Defaults
parameter
partner_admin_system_priority 0
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a partner_system_priority value from a slot and port asso-
ciated with a dynamic aggregate group.
•
The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
Chapter 1, "Ethernet Port Commands,"
Examples
-> lacp agg 2/1 partner admin system priority 65
-> lacp agg 2/1 no partner admin system priority
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Documents that the port is 10 Mbps Ethernet.
Documents that the port is 100 Mbps Fast Ethernet.
Documents that the port is Gigabit Ethernet.
The slot number for this aggregate.
The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
the aggregation group is attached. Possible values are 0–255.
default
for information on CLI commands to configure Ethernet ports.
June 2012 page 8-37