Distributed Spanning Tree Commands
bridge rrstp
Enables or disables RRSTP on a switch.
bridge rrstp
no bridge rrstp
Syntax Definitions
N/A
Defaults
By default, RRSTP is disabled on the switch.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to disable RRSTP on the switch.
•
RRSTP can be enabled on the switch only when the flat mode is active. If you try to enable RRSTP in
1x1 mode, you get an error message: "Failed to enable RRSTP because STP Mode is 1x1".
Examples
-> bridge mode flat
-> bridge rrstp
-> no bridge rrstp
-> bridge mode 1x1
-> bridge rrstp
ERROR: Failed to enable Rrstp because STP Mode is 1x1
Release History
Release 6.2.1; command introduced.
Related Commands
bridge rrstp ring
show bridge rrstp
configuration
MIB Objects
vStpInfo
VStpRrstpGlobalState
OmniSwitch CLI Reference Guide
Creates a RRSTP ring consisting of two ports.
Displays the current RRSTP status for the switch.
June 2012
page 7-117