Lacp Agg Partner Admin Key - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Link Aggregation Commands

lacp agg partner admin key

Configures the partner administrative key for a dynamic aggregate group port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin key partner_admin_key
lacp agg [ethernet | fastethernet | gigaethernet] slot/port no partner admin key
Syntax Definitions
ethernet
fastethernet
gigaethernet
slot
port
parnter_admin_key
Defaults
parameter
partner_admin_key
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a partner admin key value from a slot and port associated
with a dynamic aggregate group.
•
The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
Chapter 1, "Ethernet Port Commands,"
Examples
-> lacp agg 2/1 partner admin key 0
-> lacp agg 2/1 no partner admin key
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Documents that the port is 10 Mbps Ethernet.
Documents that the port is 100 Mbps Fast Ethernet.
Documents that the port is Gigabit Ethernet.
The slot number for this aggregate.
The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
The administrative key for the dynamic aggregation group's remote
partner. Possible values are 0–65535.
default
0
for information on CLI commands to configure Ethernet ports.
June 2012 page 8-35