IP Commands
ip interface dhcp-client
Configures a DHCP client IP interface that is to be assigned an IP address from a DHCP server.
ip interface dhcp-client [vlan vid] [release | renew] [option-60 opt60_string] [admin {enable |
disable}]
no ip interface dhcp-client
Syntax Definitions
dhcp-client
vid
release
renew
opt60_string
enable
disable
Defaults
parameter
opt60_string
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove the dhcp-client IP interface.
•
Only one DHCP client IP interface can be assigned per switch but it can belong to any VLAN and any
VRF instance.
•
If the system name has not been configured, it will be updated using the option-12 field. If the option-
12 string is greater than 19 characters the remaining characters will be truncated.
•
The minimum lease time accepted on the dhcp-client interface is 5 minutes.
Examples
-> ip interface dhcp-client vlan 100
OmniSwitch CLI Reference Guide
Reserved IP interface name indicating this interface should use DHCP
to obtain an IP address from a DHCP server.
An existing VLAN ID number (1–4094).
Releases the DHCP server assigned IP address.
Renews the DHCP server assigned IP address.
The option-60 field value to be included in DHCP discover/request
packets.
Enables the administrative status for the IP interface.
Disables the administrative status for the IP interface.
default
OmniSwitch-xxxx
(xxxx = Platform i.e.
6850)
enable
June 2012
page 14-11