Ip Route-Map Action - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IP Commands

ip route-map action

Creates a route map for redistribution and sets the status of the route map to permit or deny.
ip route-map route-map-name [sequence-number number] action {permit | deny}
no ip route-map route-map-name [sequence-number number]
Syntax Definitions
route-map-name
number
permit
deny
Defaults
parameter
number
permit | deny
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to delete the entire route map by specifying only the route-map-
name.
•
Use the no form of this command to delete a specific sequence in the route map by specifying the
sequence-number.
•
All route maps having the same name but different sequence numbers are linked together and
processed in order of increasing sequence number.
•
Use this command to change the status of an existing route map to permit or deny.
Examples
-> ip route-map route1 sequence-number 10 action permit
-> no ip route-map route1
Release History
Release 6.1.3; command was introduced.
OmniSwitch CLI Reference Guide
The name of the route map (up to 20 characters).
A number that links together the route maps. The range is 1–100.
Permits route redistribution.
Denies route redistribution.
default
50
permit
June 2012 page 14-35