Ethernet Port Commands
link-fault-propagation group
Configures a Link Fault Propagation (LFP) group to associate with source and destination ports.
link-fault-propagation group group_id [admin-state {enable | disable}]
no link-fault-propagation group {group_id[-group_id2]}
Syntax Definitions
group_id
group_id[-group_id2]
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a LFP group or a range of groups.
•
Up to eight LFP groups per switch are allowed.
•
Once a LFP group is created, assign source and destination ports to that group.
Example
-> link-fault-propagation group 1
-> no link-fault-propagation group 4
-> no link-fault-propagation group 4-7
Release History
Release 6.4.4; command introduced.
OmniSwitch CLI Reference Guide
A group ID number. The valid range is 1–8.
A group ID number to remove. Use a hyphen to specify a range of exist-
ing group ID numbers (5-8). Specifying a range is only used to remove
group IDs, not to create them.
Enables LFP for the specified group.
Disables LFP for the specified group.
default
disable
June 2012
page 1-137