Show Lldp Config - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

show lldp config

Displays the general LLDP configuration information for LLDP ports.

show lldp {slot | slot/port} config

Syntax Definitions

By default, a list of all LLDP ports with their configuration parameters is displayed.

Platforms Supported

OmniSwitch 6400, 6850, 6850E, 6855, 9000E

Usage Guidelines

Use the slot/port or slot parameter to display information for a specific port or for all ports on a specific

-> show lldp config

----------+-------------------------------------------+-----------------+-------

----------+----------+----------+----------+----------+----------+------+------

output definitions

Admin Status

Std TLV Mask

Mgmt Address

The slot number for a specific module.

Slot number for the module and physical port number on that module

(for example, 3/1 specifies port 1 on slot 3).

The LLDP slot and port number.

Indicates the Administrative status of the LLDP port.The options

are - Disabled, Rx, Tx, and Rx+Tx.

Indicates if the Notify Trap feature is disabled or enabled on a

particular port

The standard TLV mask set for the port.

Indicates whether transmission of the per port IPv4 management

address is enabled or disabled.

Indicates whether 802.1 TLV status is enabled or disabled on the LLDP

OmniSwitch CLI Reference Guide

802.1AB Commands