Mvrp Applicant - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

MVRP Commands

mvrp applicant

Configures the applicant mode of specific ports on the switch. The applicant mode determines whether
MVRP PDU exchanges are allowed on a port depending on the Spanning Tree state of the port.
mvrp {port slot/port [– port2] | linkagg agg_num [-agg_num2]} applicant {participant | non-partici-
pant | active}
Syntax Definitions
slot/port
agg_num
participant
non-participant
active
Defaults
parameter
participant | non-participant |
active
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
To use the agg_num parameter, the link aggregate group must be created and enabled.
Examples
-> mvrp port 1/2 applicant active
-> mvrp port 1/3 applicant participant
-> mvrp port 1/4 applicant non-participant
-> mvrp linkagg 10 applicant active
-> mvrp linkagg 15 applicant participant
-> mvrp linkagg 20 applicant non-participant
Release History
Release 6.4.3; command was introduced.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The number corresponding to the aggregate group.
Specifies that MVRP PDU exchanges are only allowed when the port is
in the STP forwarding state.
Specifies that MVRP PDU's are not sent in this mode and PDU's
received are processed and learning happens as expected.
Specifies that MVRP PDU exchanges are allowed when the port is in
the STP forwarding state or STP blocking state.This is applicable for
both advertisement and registration.
default
active
June 2012 page 11-13