Static Linkagg Size - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Link Aggregation Commands

static linkagg size

Creates a static aggregate group between two switches. A static aggregate group contains static links.
static linkagg agg_num size size [name name] [admin state {enable | disable}]
no static linkagg agg_num
Syntax Definitions
agg_num
size
name
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850,6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove a static aggregate group from the configuration.
•
The maximum number of link aggregate groups allowed on the switch (static and dynamic combined)
is 32 for stackable products and 128 for chassis-based products.
•
Note that a maximum of 256 link aggregation ports are supported. The number of link aggregation
ports per group will determine the maximum number of groups that can be configured. The table below
provides some example configurations:
Number of Ports in Group
2
4
8
OmniSwitch CLI Reference Guide
The number corresponding to the static aggregate group. Must be a
unique integer in the range 0–31 (stackable products) or 0–127 (chassis-
based products).
The maximum number of links allowed in the aggregate group. Values
may be 2, 4, or 8.
The name of the static aggregate group. May be any alphanumeric string
up to 255 characters long. Spaces must be contained within quotes (e.g.,
"Static Group 1").
Specifies that the static aggregate group is active and is able to aggre-
gate links.
Specifies that the static aggregate group is inactive and not able to
aggregate links.
default
enable
Maximum Number of Groups
128
64
32
June 2012 page 8-3