Erp-Ring - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet Ring Protection Commands

erp-ring

Creates an Ethernet Ring Protection (ERP) ring using the specified ports and service VLAN ID. The
service VLAN transmits ERP control traffic, such as Ring Automatic Protection Switching (R-APS)
messages, through the ring and the specified level number identifies an APS Management Entity Group
(MEG) to which the service VLAN belongs.
erp-ring ring_id port1 {slot/port | linkagg agg_num} port2 {slot/port | linkagg agg_num} service-vlan
vlan_id level level_num [guard-timer guard_timer] [wait-to-restore-timer wtr_timer] [enable | disable]
no erp-ring ring_id
Syntax Definitions
ring_id
slot/port
agg_num
vlan_id
level_num
guard-timer
wtr-timer
enable
disable
Defaults
parameter
guard_timer
wtr_timer
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove a ring from the switch configuration. Note that adminis-
tratively disabling ring ports is recommended before deleting the ring to avoid creating any network
loops. Once the ring is deleted, then ensure that the same ports are administratively enabled under
Spanning Tree control.
•
The specified ring identification number must be unique within a switch.
OmniSwitch CLI Reference Guide
The ERP ring ID number. The valid range is 1- 2147483647.
The slot number for the module and the physical port number on that
module.
The link aggregate ID number.
The service VLAN ID number.The valid range is 1- 4094.
The MEG level number for the service VLAN. The valid range is 0-7.
The guard timer value, in centi-secs, for the ring node.
The wait-to-restore timer value, in minutes, for the Ring Protection Link
(RPL) node.
Administratively enables the ERP ring.
Administratively disables the ERP ring.
default
50
5
disable
June 2012 page 9-3