Interfaces Flood - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet Port Commands

interfaces flood

Enables broadcast, multicast or unknown unicast traffic storm control on the specified interface.
interfaces {slot | slot/port[-port2]} flood [broadcast | multicast | unknown-unicast | all] [enable |
disable]
Syntax Definitions
slot
slot/port[-port2]
broadcast
multicast
unknown-unicast
all
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Enter a slot number to enable or disable traffic storm control for all interfaces on a specific slot.
•
Enter a slot and port number or a range of port numbers to enable or disable traffic storm control on a
specific interface or range of interfaces.
•
The keyword all applies to all traffic types; broadcast, multicast and unknown-unicast.
Examples
-> interfaces 3 flood broadcast enable
-> interfaces 1/47 flood broadcast enable
-> interfaces 3 flood multicast enable
-> interfaces 1/45-48 flood multicast enable
-> interfaces 3 flood unknown-unicast enable
-> interfaces 1/47 flood unknown-unicast enable
OmniSwitch CLI Reference Guide
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Packets with a destination MAC address of FF:FF:FF:FF:FF:FF.
Packets with a multicast MAC address.
Unicast packets with an unknown destination MAC address.
Applies to broadcast, multicast, and unknown unicast packets.
Enables broadcast, multicast, or unknown unicast rate limiting.
Disables broadcast, multicast, or unknown unicast rate limiting.
default
disable
June 2012 page 1-33