Ethernet Port Commands
show interfaces hybrid capability
Displays default auto negotiation, speed, duplex, flow, and cross-over settings for a single combo port, a
range of combo ports, or all combo ports on a switch.
show interfaces [slot | slot/port[-port2]] hybrid {fiber |copper} capability
Syntax Definitions
slot
slot/port[-port2]
fiber
copper
Defaults
By default, displays information for all ports on all modules.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
Usage Guidelines
•
This command displays defaults settings in two rows of data for each combo port. The first row of
data, identified by the label CAP, displays the valid user-defined configuration settings available for
the combo port. The second row, identified by the label DEF, displays the default settings for the
combo port.
•
Enter a slot number to display information for all interfaces on a specific slot.
•
Enter a slot and port number or a range of port numbers to display information for a specific interface
or a range of interfaces.
Examples
-> show interfaces 1/47 hybrid copper capability
Slot/Port
AutoNeg
-----------+---------+--------+-----------+----------+----------
1/47 CAP
EN/DIS
1/47 DEF
output definitions
Slot
Port
OmniSwitch CLI Reference Guide
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Specifies that the configuration of the SFP port(s) will be displayed.
Specifies that the configuration of the copper 10/100/1000 RJ-45 port(s)
will be displayed.
Flow
Crossover
EN/DIS
MDI/X/Auto
EN
EN
Auto
The slot number.
The port number
June 2012
Speed
Duplex
10/100/1G
Full/Half
Auto
Auto
page 1-111