Lldp Trust-Agent Violation-Action - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

802.1AB Commands

lldp trust-agent violation-action

Sets the action to be performed when a violation is detected.
lldp {slot/port| slot | chassis} trust-agent violation-action {trap-and-shutdown | trap | shutdown}
Syntax Definitions
slot/port
slot
chassis
trap-and-shutdown
trap
shutdown
Defaults
By default, trust agent violation action is set to 'trap'.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
If the port is in a shutdown state, clear the violation on the port by using the command "interfaces
slot[/port[-port2]] clear-violation-all"
•
Clearing the violation on a port does not clear the trusted remote agent existing on that port. To clear
the trusted remote agent, disable the LLDP security mechanism on the port.
•
If the port is in a shutdown state due to violation and the port link is toggled, only the link goes up. The
port still remains in the violation state and the trusted remote agent existing on that port is not cleared.
Examples
-> lldp chassis trust-agent violation-action trap
-> lldp 3 trust-agent violation-action shutdown
Release History
Release 6.4.4; command introduced.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (for example, 3/1 specifies port 1 on slot 3).
The slot number for the module (for example, 3 specifies slot 3)
All switch ports.
Shuts down the port and sends a trap notification when a violation is
detected.
Sends a trap notification when a violation is detected.
Shuts down the port when a violation is detected.
June 2012 page 12-49