Show Mac-Address-Table Vpls Sap - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show mac-address-table vpls sap

Displays Source Learning MAC Address Table information for the specified VPLS Service Access Point
(SAP) binding.
show mac-address-table vpls service-id sap {sap-id | linkagg sap-id} mac-address
Syntax Definitions
service-id
sap-id
mac-address
Defaults
N/A
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
The specified VPLS ID and SAP ID must already exist in the VPLS configuration for the switch. See
the "VPLS Commands" chapter in this guide for information about how to configure a VPLS and SAP.
•
A SAP ID is comprised of an access (customer-facing) port or link aggregate and an encapsulation
value that is used to identify the type of customer traffic to map to the associated service.
Example
-> show mac-address-table vpls 1002 sap linkagg 16:1006
Legend: Mac Address: * = address not valid
Domain Vlan/SrvcId
-----+-----------+-----------------+--------+-------+---------+------------
VPLS 1002
Total number of Valid MAC addresses above = 1
output definitions
Domain
VLAN/SrvcId
Mac Address
Type
Protocol
page 4-22
An existing VPLS ID number.
The access slot and port number or link aggregate ID (0–31) and encap-
sulation value for an existing SAP (e.g., 1/10:0, 1/12:all, 20:150, 10:all).
A 48-bit MAC address (aa:bb:cc:dd:ee:ff). Valid addresses are any non-
broadcast, non-multicast MAC, and non-IEEE reserved addresses.
Mac Address
00:01:db:07:03:02
The domain to which the MAC address belongs: VLAN or VPLS.
The VPLS ID number associated with the MAC address.
MAC address that is currently learned or statically assigned.
MAC address management status: learned or permanent.
Protocol type for the MAC address entry. Note that if the hardware
source learning mode is active for the port, this field is blank.
Type Protocol Operation Interface
learned --- servicing sap:0/16:1006
OmniSwitch CLI Reference Guide
Source Learning Commands
June 2012