Interfaces Hybrid Preferred-Fiber - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

interfaces hybrid preferred-fiber

Configures one or more combo ports to use the fiber SFP port(s) instead of the equivalent copper 10/100/
1000 RJ-45 port(s), when both ports are enabled and have a valid link. In addition, this mode configures
automatic failover to copper if a valid copper link is present on RJ-45 side and fiber link fails to come up.
interfaces {slot | slot/port[-port2]} hybrid preferred-fiber
Syntax Definitions
slot
slot/port[-port2]
Defaults
All combo ports are set to preferred fiber by default.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
Usage Guidelines
This command is no longer required, preferred-fiber is the only mode supported.
Examples
-> interfaces 1/47 hybrid preferred-fiber
-> interfaces 1/47-48 hybrid preferred-fiber
-> interfaces 1 hybrid preferred-fiber
Release History
Release 6.1; command was introduced.
Release 6.4.4; preferred-fiber is the default setting and cannot be changed.
Related Commands
show interfaces hybrid status
MIB Objects
esmHybridConfTable
esmPortCfgHybridMode
esmPortCfgHybridType
page 1-56
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
Displays interface line settings (for example, speed, mode) for
combo ports only.
Ethernet Port Commands
OmniSwitch CLI Reference Guide June 2012