Customizing The Screen Display; Changing The Screen Size; Changing The Cli Prompt - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

Using the CLI

Customizing the Screen Display

The CLI has several commands that allow you to customize the way switch information is displayed to
your screen. You can make the screen display smaller or larger. You can also adjust the size of the table
displays and the number of lines shown on the screen.
Note. Screen display examples in this chapter assume the use of a VT-100/ASCII emulator.

Changing the Screen Size

You may specify the size of the display shown on your terminal screen by using the
command is useful when you have a small display screen or you want to limit the number of lines scrolled
to the screen at one time. For example, to limit the number of lines to 10 and the number of columns to
150, enter the following:
-> tty 10 150
The first number entered after tty defines the number of lines on the screen. It must be a number between
10 and 150. The second number after tty defines the number of columns on the screen. It must be a
number between 20 and 150. You may view the current setting for your screen by using the

Changing the CLI Prompt

You can change the system prompt that displays on the screen when you are logged into the switch. The
default prompt consists of a dash, greater-than (
prompt from -> to ##=> use the
->
-> session prompt default ##=>
##=>
The switch displays the new prompt string after the command is entered.
OmniSwitch AOS Release 7 Switch Management Guide
) text string. To change the text string that defines the
->
session prompt command as follows:
March 2011
Customizing the Screen Display
tty command. This
tty command.
page 4-9