Circle Setting (Ec Circle Search) - Omron XPECTIA FZ3 User Manual

List of EC Circle Search Items
EC circle search items are explained below.
Item name
Circle This item sets the size of the circle to search for.
register Reference:
This item is used to set up the measurement area.
Region Narrowing the measurement area instead of measuring the entire input screen shortens the
setting processing time.
Reference:
This item can be changed if necessary.
Ref. position Usually, the central position of the registered region is specified as the reference position.
Reference:
This item can be changed if necessary.
Select the color of the circle and the background color.If no check is placed at color setting, the
Color setting
circle (edge) is extracted using the brightness difference.
Reference:
This item changes the measurement parameter as necessary when the measurement result is
Measurement unstable.
Reference:
This item can be changed if necessary.
Output Normally, the factory default value will be used.Use the output parameter to specify how to handle
parameter the coordinates.
Reference:

Circle Setting (EC Circle Search)

This item registers the size of the circle to search for.
Set the circle size only with the circumference figure.
1.
In the Item Tab area, tap [Circle register].
When setting a new circle, you do not need to tap [Circle register].
2.
Set the search circumference using the drawing tools.
3.
In the figure setting area, tap [OK].
The circle to search for is registered.
4.
Tap [Edge extraction] and set values.
Reference: Extracting edges (p.85)
Extracting Edges
In an EC circle search, processing is executed on the edge extraction image.Change this item as
necessary when the edge is not extracted or is extracted along with noise.
1.
In the Item Tab area, tap [Edge extraction].
2.
In the "Edge extraction setting" area, tap [...] or [
The "Edge level" value can be specified by dragging the slider or tapping one of the buttons at
either end of the slider.
FZ3 Processing Items List Manual
Circle Setting (EC Circle Search) (p.85)
Region Setting (EC Circle Search) (p.86)
Reference Position (EC Circle Search) (p.87)
Color Specification (EC Circle Search) (p.88)
Measurement Parameters (EC Circle Search) (p.89)
Output Parameters (EC Circle Search) (p.91)
Description
] for each item and set the values.
EC Circle Search 85
2