Measurement Parameters (Scan Edge Width) - Omron XPECTIA FZ3 User Manual

This sets the allowable color difference for detecting the edge, using the specified
Difference
color as the reference.The larger the difference values, the larger the color range
R, G, B
that is used to detect the edge.
Color IN: The position where a color other than the specified color changes to the
specified color is detected as the edge.
Color OUT: The position where the specified color changes to a color other than the
specified color is detected as the edge.
Detection
mode

Measurement Parameters (Scan Edge Width)

Measurement parameters can be changed as needed to address unstable measurement
results.Normally, the factory default value will be used.
After changing a setting, check whether measurement can be done properly by performing an actual
measurement.
1.
In the Item Tab area, tap [Measurement].
The edge profile of the measurement region is displayed as a graph in the Image Display area.
2.
Set the value of each item in the "Display area" area.
FZ3 Processing Items List Manual Scan Edge Width 149
2