Understanding Setting Operations
2-3
Understanding Setting Operations
2-3-1
STEP 1: Starting Conversational Menus
This section uses a simple example to explain the procedures for using Con-
versational Menus, from setting inspection conditions through to starting
inspection. The example used is a presence inspection. The operating guides
displayed on the screen can be used just like a conversation to help perform
procedures.
1.
The screen shown below will be displayed when the Conversational
Menus are started for the first time.
0.Scn 0
MON
press ENT at MON and
then select SET from
S+↑ ↓:Mem img
2.
Move the cursor to MON and press the ENT Key.
A list of modes will be displayed.
0.Scn 0
MON
SET
SET
MON
RUN
SYS
TOOL
SAVE
3.
Use the Up and Down Keys to move the cursor and select SET.
The F160 will enter Set Mode.
Start setting?
Start
Cancel
4.
Select Start to start making the settings.
Follow the instructions given by the operation guide displayed on the
screen for the rest of the procedure.
----
---ms
For a new scene,
the menu.
Freeze
----
---ms
Section 2-3
21