Table of Contents
Advertisement
2.
Use the drawing tools to specify the model registration range.
2
3.
To save the entire image used for model registration, place a check at the "Save registered
model" option.
Note
If you save the registered model image, you can re-register the model with the same image after model
●
parameters are adjusted.Note that the scene data size increases when a registered model image is
saved.
4.
Tap [OK].
The model is registered.
Note
When a model is registered, the central coordinates of the model are registered as the detection point.A
●
detection point is a point output as a measurement value. If multiple figures are combined, the central
coordinates of the circumscribed rectangle are registered.
Changing Model Parameters
Model parameter values can be changed as needed to address unstable measurement results or to
increase the processing speed.Normally, the factory default value will be used.
After changing a setting, re-register the model.
1.
In the "Model parameter" area, select the search mode, then specify a value for each item for
44
Search
FZ3 Processing Items List Manual
Advertisement
Table of Contents
