Measurement Results For Which Output Is Possible (Shape Search+) - Omron XPECTIA FZ3 User Manual

When the measurement results are unstable
Parameter to
be adjusted
Model
2
parameter
Measurement
When the processing speed is slow
Parameter to
be adjusted
Model
parameter
Region
setting
Measurement

Measurement Results for Which Output Is Possible (Shape Search+)

The following values can be output using processing items related to results output.It is also possible to
reference measurement values from expressions and other processing units.
Judgement
Count
Correlation value
Measurement coordinate X
Measurement coordinate Y
Measurement angle
Magnification X
Magnification Y
Reference position X
Reference position Y
Reference angle
Detection point X
Detection point Y
Correlation 0
102 Shape Search+
Register the model from the following two perspectives.
Register the model figure frame enclosing the boundaries of the target.
●
In order to detect based on the edge information, improvement is made by including boundary
information in the registration.
When a model is registered near the boundary of the image or measurement region, some
●
targets may be impossible to detect.
Register the model leaving space from the boundary of the image or measurement region.
Specify a larger value for "Candidate level".
●
Specify a smaller value for the "Search skipping Level" in the detailed settings.
●
These two settings have a trade-off with speed.
Make the setting taking the affect on speed into consideration.
Specify a narrower "Angle range".
Specify a smaller value for "Region".
Set the "Subpix level" in the detailed settings to "Fast".
●
This setting has a trade-off with precision.
Change this setting according to what the application is used for.
Specify a larger value for "Candidate level".
●
Specify a smaller value for the "Search skipping Level" in the detailed settings.
●
These two settings have a trade-off with speed.
Make the setting taking the affect on speed into consideration.
Displayed items
Remedy
Remedy
Description
JG Judgement result
C Count
CR Correlation with the model
X Measure X
Y Measure Y
TH Measure angle
MX Magnification X
MY Magnification Y
SX Reference
SY Reference
ST Reference angle
RX Detected coordinate X
RY Detected coordinate Y
CR00 Correlation 0
Description
FZ3 Processing Items List Manual