Table of Contents
Advertisement
Model
parameter
2
Measurement
Measurement Results for Which Output Is Possible (Search)
The following values can be output using processing items related to results output. It is also possible to
reference measurement values from expressions and other processing units.
Measurement items
Judgement
Count
Correlation value
Measurement coordinate X
Measurement coordinate Y
Measurement angle
Reference position X
Reference position Y
Reference angle
Detection point RX
Detection point RY
Correlation value N (N = 00
to 31)
Position N (N = 00 to 31)
Position N (N = 00 to 31)
Angle N (N = 00 to 31)
52
Search
If the model image is a simple figure or a large figure, specify a smaller value for "Stab."If lowering
stability does not speed up processing, it is likely that many candidates have been detected. Raise
the "Candidate LV" in [Measurement].
When "Rotation" is selected and the model image is a simple figure, specify a larger value for
"Skipping angle".
When "Rotation" is selected and the model image is a simple figure, place a check at "Smart mode".
If the position precision is high, specify a smaller value for "Prec.".
If the rotation angle range is large, set the "Search mode" to "PT".
If images that should be judged OK vary little, specify a larger value for "Candidate LV".
If the position precision is high, uncheck "Sub-pixel".
Character
string
JG
C
CR
X
Y
TH
SX
SY
ST
RX
RY
CRN
XN
YN
THN
Judgement result
Number of search items detected
If none detected, 0
Correlation value with the model
X coordinate of the position where the model is detected
Y coordinate of the position where the model is detected
Angle of the position where the model is detected
X coordinate of the reference position of the registered model
Y coordinate of the reference position of the registered model
Angle of the registered model
X coordinate of the registered model
Y coordinate of the registered model
Detected search N correlation value (N = 00 to 31)
Detected search N position X (N = 00 to 31)
Detected search N position Y (N = 00 to 31)
Detected search N angle TH (N = 00 to 31)
Description
FZ3 Processing Items List Manual
Advertisement
Table of Contents
