Table of Contents
Advertisement
Setting item
Keep disabled
setting
Save
registered
2
model.
4.
Tap [OK].
The model is registered.
Changing Model Parameters
Model parameter values can be changed as needed to address unstable measurement results or to
increase the processing speed.Normally, the factory default value will be used.
After changing a setting, re-register the model.
1.
In the "Model parameter" area, set each item.
Rotation
Smart mode
Stability
Preciseness
Changing Sub-model parameter
Set the "Sensitive model setting" as necessary.
64
Sensitive Search
Set value
[factory default]
When the model is registered, this holds the disable setting for
[Checked]
●
the sub-region set during the last time the model was
Unchecked
●
registered.
Checked
To save the entire image used for model registration, place a
●
[Unchecked]
check at this option.
●
Set value
Setting item
[factory default]
Checked
●
[Unchecked]
●
Angle range
[-180 to 180]
Skipping
1 to 30
angle
[5]
[Checked]
●
Unchecked
●
1 to 15
[The default
value depend on
the connected
camera.9 or 12]
1 to 3
[2]
Description
Description
When the measurement object is rotating, place a
check at "Rotation" and specify how many degrees
the model created rotates each time and through
what range of angles.A smaller skipping angle
increases stability, but slows down the
processing.The normal direction is clockwise.
Checking the "Smart mode" option enables a
high-speed rotation search.However, the stability
may be lowered when the model shape aspect
ratio is large or when the NOT mask is used.
Specify which is to have priority, measurement
stability or speed.
If lowering stability does not speed up processing,
it is likely that many candidates have been
detected.In this case, specify a larger value for
"Candidate level" or "Stab."
Specify which is to have priority, measurement
positional precision or speed.
FZ3 Processing Items List Manual
Advertisement
Table of Contents
