Troubleshooting And Front Panel Messages - Paradyne COMSPHERE
3610 User Manual

Troubleshooting
Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Messages Format
Troubleshooting
Confirm the installed hardware options. You receive a
power-up message for each hardware option type; for
example:
DSU Pass
MUX Pass (TDM or MCMP)
DBM Pass
If a fail message appears or a hardware option does not
appear, go to the Configuration (Config) branch, load, and
save a factory-set configuration (FacC or FacT). Refer to
the Power-Up Routine section in Chapter 2.
If the DSU is not connected to the network yet, the:
Red Alrm indicator is lit
LCD displays DDS F:No Signal, indicating a
facility alarm
LCD displays Health and Status information
Procedure
If the DSU fails the power-up test:
1. Go to the Test branch.
2. Re-execute the Device Test (Devic). If the test
passes, continue operating the DSU.
If the device test fails again, call your sales or service
representative.
3610-A2-GB46-60
Troubleshooting and
Front Panel Messages
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
December 1996
Messages
This section describes the informational messages that
may appear on the DSU's front panel when:
Using the Async Terminal feature
Executing a command
An error condition prevents execution of a
command
The messages listed here do not include menus, data
entry displays, or specific test results; they do give the
condition for the message and any action to perform.
Table E-1 lists command progress messages.
Table E-2 identifies and describes front panel
messages displayed when async terminal is
enabled.
Table E-3 lists command error messages.
Table E-4 contains configuration error messages
that may appear when the verification routine runs
after pressing SAVE.
Table E-5 lists device health and status messages.
Table E-6 presents subnetwork health and status
messages.
For configuration error messages supporting
TDM, MCMP, and digital bridging, refer to
Document No. 3610-A2-GB48.
For configuration error, progress, and health and
status messages supporting DBMs, refer to Document
No. 3610-A2-GB49.
E
E-1
E-1
E-2
E-1