H System Health And Test Status Messages; Health And Status Messages - Paradyne 9161 User Manual

System Health and Test Status Messages

Health and Status Messages

9161-A2-GH30-40
Table 7-1. System Status Messages (2 of 2)
Message What It Indicates
Please Wait Command takes longer than
5 seconds.
User Interface Already Access to the user interface
in Use via Telnet is in use; access to
the interface is denied.
IP address and login of the
user currently accessing the
interface are also provided.
User Interface Idle
Previously active session is
now closed/ended, and
access via the COM port is
now available.
Session has ended due to
timeout.
The System and Test Status screen ( Path: main status system test status )
displays the following types of messages:
H
Health and Status – Displays Health and status information in priority order
(highest to lowest).
H
Self-Test Results – Displays the results of the power-up self-test
diagnostics.
H
Test Status – Indicates which tests are currently active.
These messages appear in the first column of the System and Test Status screen
in priority (highest to lowest) order, as shown in
Clear device failure messages from the System Health and Status screen using
the following menu selection sequence:
Main Menu Control
Table
Clear Device Fail
April 1999
Displaying System Information
What To Do
1. Wait until message clears.
2. If the message does not
clear within 2 minutes, reset
the device.
1. Wait and try again.
2. Contact IP address user
and request that they log
off.
Log onto the access unit.
Normal condition; no action
needed.
7-2.
7-17