Manual Dialing Out When An Alarm Occurs - Paradyne 9161 User Manual

Troubleshooting

Manual Dialing Out When an Alarm Occurs

"
9-20
6. Press Ctrl-a to switch to the screen function key area.
7. To save changes, select Save and press Enter. The Save Configuration To
screen appears.
8. Select the configuration area where you want to save the changes to and
press Enter. When Save is complete, Command Complete appears at the
bottom of the screen.
Configure the external device connected the the access unit's COM port. Then,
use the COM Port Call Setup screen to:
H
Select the desired telephone number.
H
Dial a call.
H
Disconnect a call.
Procedure
1. Follow this menu selection sequence:
Main Menu Control
2. Enter the desired directory number, or press the spacebar to cycle through
the numbers that have been set up in the directory. The telephone number
appears in the Directory Phone Number field.
See Displaying Directory Numbers and Changing Directory Numbers
Chapter 8, Operation and Maintenance , for information about the call
directory.
3. Select Dial and press Enter to initiate dialing.
4. To end the call, select Disconnect and press Enter.
COM Port Call Setup
April 1999
in
9161-A2-GH30-40