Aborting All Tests; Determining Test Status And Results; Hot Swapping Of Apms - Paradyne 9161 Reference Manual

Aborting All Tests

Determining Test Status and Results

Hot Swapping of APMs

9161-A2-GH30-20
Use the Abort All Tests selection from the Test menu to abort all tests running on
all interfaces, with exception to Network- or DTE-initiated loopbacks. To abort
individual tests that are active, see
Procedure
To abort all tests on all interfaces:
1. Follow this menu selection sequence:
Main Menu Test
2. Select Abort All Tests and press Return.
Command Complete appears when all tests on all interfaces have been
terminated.
NOTE:
Abort All Tests does not interrupt DTE-initiated loopbacks.
Current test status and results are available on the:
Test screen from where you execute the test
System and Test Status screen
NMS
Test LED
For more information on interpreting results and messages, refer to Chapter 5,
Maintenance and Troubleshooting , in the User's Guide .
The T1 access unit allows you to insert and remove APM cards and their
matching I/O cards without powering down the unit or interrupting data on the
network or on other APMs. The T1 access unit automatically recognizes when an
APM is inserted or removed, and can display the configuration option settings
and MIB objects applicable to the APM that was inserted or removed.
NOTE:
You do not have access to screens and configuration options that are not
valid for the given configuration, nor can you preconfigure or predelete a
configuration for an APM prior to inserting it in the housing. To see
configuration options for an inserted APM, you must exit the configuration
screen, then reenter it.
September 1997
Troubleshooting and Maintenance
Starting and Stopping a Test on page 5-32.
5-33