Paradyne 9161 User Manual page 197

9161-A2-GH30-40
Table 9-1. ASCII Alarm Messages (3 of 5)
Message
month/day/year
hours:minutes:seconds –
Alarm Cleared for a DDS
Network Failure code at
OCU-DP port in slot ss
port p .
month/day/year
hours:minutes:seconds –
An Excessive Error Rate
(EER) has been detected at
the Network 1/ Network 2
Interface.
month/day/year
hours:minutes:seconds –
Alarm Cleared for
Excessive Error Rate
(EER) at the Network
1/Network 2 Interface.
month/day/year
hours/minutes/seconds –
An Excessive Error Rate
(EER) has been detected at
synchronous data port in
slot ss port p .
month/day/year
hours:minutes:seconds –
Alarm Cleared for
Excessive Error Rate
(EER) at synchronous data
port in slot ss port p .
month/day/year
hours:minutes:seconds –
A Loss of Loop Timing has
been detected at OCU-DP
port in slot ss port p .
month/day/year
hours:minutes:seconds –
Alarm Cleared for Loss of
Loop Timing at OCU-DP
port in slot ss port p .
month/day/year
hours:minutes:seconds – A
Loss Of Signal (LOS) has
been detected at the
OCU-DP port in slot ss
port p .
April 1999
What It Indicates What To Do
Alarm condition no No action needed.
longer exists.
An Excessive Error Contact network
Rate condition is provider.
detected on the
network interface.
Alarm condition no No action needed.
longer exists.
An excessive error There is a network
rate occurred on the problem with the
synchronous data port fractional portion of
for the identified slot the link carrying this
and port. port's data. Contact
network provider.
Alarm condition no No action needed.
longer exists.
The specified Check that the CPE
OCU-DP port cannot CSU/DSU rate
recover timing from matches the OCU-DP
the received signal on rate.
the local loop.
Alarm condition no No action needed.
longer exists.
LOS condition 1. Check the cable to
detected.
2. Contact network
Troubleshooting
Priority
12
14
20
16
the OCU-DP port.
provider.
9-15