Paradyne 9161 User Manual page 99

"
9161-A2-GH30-40
Procedure
1. Follow this menu selection sequence:
Configuration Edit/Display
Assignment
2. The Sync Data Port Assignments screen appears. Enter one of the following
into the Assign To field:
If you want to assign to . . .
Network interface time slots
DSX-1 interface time slots on the 9161
Single T1 NAM
Another Sync Data port
3. Enter the number of DS0s to allocate.
4. Enter one of the following into the Assign By field:
Enter . . . To . . .
Channel Assign ports individually. However, a Sync Data port can be
assigned to multiple time slots which do not have to be
contiguous. As you assign multiple time slots to a port, the data
port rate increases by the Port Base Rate defined on the
Synchronous Data Port Options screen (see
Data Ports
Block Assign a block of contiguous channels by specifying the number
of DS0s. The number of DS0s is limited to the largest
contiguous block of time slots, and only starting time slots that
have enough contiguous time slots following will be selectable.
ACAMI Assign a block of contiguous channels as in the Block method,
except that the number of channels assigned is twice the
number of DS0s to allocate. Every other time slot is filled with all
ones to maintain ones density on the interface.
5. Move the cursor to the next editable time slot (underlined). Use the spacebar
or type in the desired slot and port. Repeat this step until all desired time
slots are assigned.
6. Select Save to save the assignments, or press ESC to save and return to the
Cross Connect menu.
Cross Connect
Then enter . . .
Net1 or Net2
DSX01-1
Port
on page 5-16).
April 1999
Setting Up
Sync Data Port
Configuring Sync
5-45